The basic requirements of electronic products for packaging design
The distinctive feature of electronic products is that they are most afraid of the threats of collision, extrusion, moisture, high temperature and static electricity. Therefore, the packaging process design of electronic products should focus on starting from these basic requirements and adopt corresponding technical measures to control. In view of the fact that most electronic products are precision industrial products, the packaging design should take into account that during transportation, handling, and storage, the packaging can withstand a certain external force collision and impact to prevent damage to the casing or movement components; it can resist external forces or The mutual squeezing of various packaging boxes during stacking or transportation bumps to prevent the deformation of the packaging or products; can resist the wetting of fog, dew, rain, steam, and effectively prevent the oxidation, rust, short circuit of electronic products, etc. The occurrence of problems; it should have good anti-radiation performance, have the ability to withstand sunlight without absorbing solar heat, prevent deformation and damage of the product casing or movement; it can effectively suppress the occurrence of vibration and friction during transportation and handling To prevent damage to electronic products caused by static electricity or cause accidental fire accidents.
Technical Control of Electronic Product Packaging Design
In the daily production process, due to poor design considerations, there are many defects in the packaging. For example, in the plate design, the direction of the overlapping tongue of the side of the carton is placed on the front, causing the flap and the side of the lid to be shaken after the carton is formed. Corresponding to the overlapping tongue. In this way, on the one hand, it is easy to touch the lap tongue when the buckle tongue is buckled, on the other hand, the carton is affected by the thickness of the lap tongue after the buckle buckle, so that there is a clear gap near the side of the lap tongue. Therefore, during plate making and imposition, the side lap tongue should be designed on the same side layout as the buckle tongue, so that the lap portion of the lap tongue does not collide with the buckle tongue to ensure the molded hood There is no obvious gap in the tongue. In addition, whether the design of the length of the lap tongue is appropriate affects the use effect of the packaged products. If the length of the lap tongue of the carton is too small, it is easy to cause mutual adhesion due to glue overflow during glue application and bonding. If it is too small, the adhesion and overall strength of the carton are significantly reduced, which affects the use of the packaging. Therefore, the length of the lap tongue of the general small carton is not less than 1.2cm, and the length of the lap tongue of the carton is not less than 2.6cm, so as to better ensure the bonding strength and improve the performance of the packaging.
Yogurt Parfait Cups,Yogurt Cup With Spoon,Food Grade Plastic Yogurt Cup,Reusable Plastic Cup With Lid
Shantou Oudaya Packaging Co. Ltd. , https://www.imloudaya.com